WS2812B WS2811 WS2801 LED WiFi Controller, iOS Android App Wireless Remote Control DC 5V~24V SP108E for SK6812 SK6812-RGBW WS2812 WS2813 WS2815 AL2815 Digital Addressable RGB LED Pixels Strip

$22.99

  • Brand: ALITOVE
  • Product Code: SP108E
  • Availability: In Stock
  • Ex Tax: $22.99

Product Description

WS2812B WS2811 WS2801 Addressable LED Strip WiFi Controller iOS Android App Remote Control SP108E 01

Precautions:

  1. The controller cannot regulate the output voltage at the VCC. That means the output voltage of your power supply must be the same as the work voltage of your led lights. If your lights need 5V input, please use a 5V power supply, never use 12V or 24V power supply.
  2. It can only support 2.4Ghz WIFI, cannot support 5Ghz WIFI when it is used at STA mode (LAN connection mode) .
  3. When connect to wifi network at STA mode (LAN connection mode) , the distance between the controller and the wifi router is within three meters. Once the controller is powered, please input wifi pin code within the 20 seconds.

Working Mode

A.AP(Access Point) mode:Controller and Phone connect directly, controller works as an access point.

1. Go to your phone Settings,find and connect the controller(named like SP108E_XXX, the default password is 12345678);

2. Open the LED Shop App ,then the controller will be showed on the device list;

B.STA(Station) mode: Controller and phone are in one same WiFi network, in this network, users can operate the controller smoothly.

There are two ways to configure the controller into the local WiFi network:

•SmartConfig Automatic Mode (This mode requires your phone has connected to a 2.4GHz WiFi)

1. Make sure your phone is connected to a WiFi network, pressing the Add Device button;

2. Input your WiFi password, pressing next step and select Automatic mode, long press the button of the controller until the LED indicator flash green; 3. Pressing the OK to confirm and wait for the configure processing finish;

4. After the configuration is finished, the LED indicator will turn into solid green, drag to refresh the device list, and the controller will be showed on the device list.

•Manual Configure Mode (This mode requires your phone has connected to a 2.4GHz WiFi or has connected to a 2.4GHz&5GHz combined WiFi netwok)

1. Make sure your phone is connected to a WiFi network, pressing the Add Device button;

2. Input your WiFi password, pressing next step and select Manual mode, click the button of the controller to switch the controller to AP mode(the LED indicator will turn into solid blue);

3. Go to your phone Settings,find and connect the controller(named like SP108E_XXX, the default password is 12345678);

4. Go back to the APP and pressing next step to start the configure processing; 5. After the configuration is finished, the LED indicator will turn into solid green, drag to refresh the device list, the controller will be showed on the device list.

Removing device: User can select the controller and remove it out of the network by pressing the Remove Device button on the APP, or just click the button of the controller to switch the controller into AP mode.

Write a review

Note: HTML is not translated!
    Bad           Good